Installation Instructions
:
Separate the hook and loop fastener into 2
pieces. Cut one piece in half (fig.1) creating
two 2” pieces (C) that will later be attached to
the chair base. With the remaining fastener,
cut two ¾” strips. Discard the rest. Peel off
the adhesive backing and place on each
Rocker Limiter as shown (D).
Turn the chair on its left side: the leg extension
handle will be visible (fig. 2). Using a flathead
screwdriver, pry the plastic floor protectors
from each corner of the chair base.
Install Chair Lifts to the chair base with the
provided screws. Make sure Recliner Riser (A)
is in front and Recliner Riser (B) is in back.
Also, make sure Recliner Risers are snug to
chair when the screws are installed. This will
ensure a proper fit.
Clean any dust from chair base where fastener
piece (C) will be attached (fig.3). Remove
adhesive backing and apply up to top edge of
base. Holding the tab of the left Rocker
Limiter, place on fastener piece (C) – the screw
will install later.
Note: Moving the Rocker Limiter along the 2”
inch strip closer or away from the spring
complex determines where the chair will stop
when one stands up. Adjust to users comfort.
Once the preferred setting is found, place a
screw through the hole as shown.