Standen TSP 1900, Operator'S Handbook Manual

Page: 17 / 61

Harvester Wheel Setting
The harvester wheels are adjustable to suit wheelings of 68” to 96”.
Before commencing wheel adjustment, ensure adequate jacks and axle
stands are available along with suitable wheel chocks.
It is important that the harvester is correctly fitted to the tractor and the
handbrake is fully applied while wheel adjustments are made.
1.
Place chocks at the front and rear of the opposite wheel to the one being
adjusted.
2. Jack up the harvester and place stands under the side beam.
3. Slacken the clamp bolt (item 1, fig 4) and remove the axle pin (item 2, fig 4).
4. Remove the top securing bolts x2 (item 3, fig 4).
5. Remove the track rod bolts x2 (item 4, fig 4).
6. Slide the wheel to the required setting (see fig 5).
7. Refit the axle pin (item 2, fig 4) and top securing bolts x2 (item 3, fig 4).
8. Retighten the clamp bolt (item 1, fig 4).
9. Finally, refit the track rod bolts x2 (item 4, fig 4).
10. Repeat for the opposite wheel.
INSTALLATION 1.12
Fig 4