Standart Horizon QUANTUM AIS GX6000, Owner'S Manual, Page: 23 / 32

Page 21 GX6000
7.5.4 NMEA 0813/NMEA 0183-HS to Chart Plotter
4800 Baud Connections
GPS Chart Plotter Plotter Connection Radio Wires
No Connection
No Connection
NMEA IN (+)
NMEA-HS IN (+)
NMEA IN (−)
NMEA-HS IN (−)
Gray: NMEA OUT (+)
Brown: NMEA OUT (−)
Yellow: NMEA-HS OUT (+)
White: NMEA-HS OUT (−)
Blue: NMEA IN (+)
Green: NMEA IN (−)
External GPS Antenna
SCU-31 (optional)
Wire Color/Description Connection Examples
BLUE - NMEA GPS Input (+)
No connection
GREEN - NMEA GPS Input (−)
No connection
GRAY - NMEA DSC Output (+) NMEA (+) input of GPS*
1
BROWN - NMEA DSC Output (−) NMEA (−) input of GPS*
1
YELLOW - AIS Data Output (+) NMEA-HS (+) input of AIS receiver*
2
WHITE - AIS Data Output (−) NMEA-HS (−) input of AIS receiver*
2
*1: 4800 baud *2: 38400 baud
Note
: Some GPS chart plotters have a single wire for NMEA signal ground. In such a case connect
the NMEA input (−) to the GPS chart plotter’s single NMEA signal ground wire, and leave the NMEA
output (−) open. In case the assignment of power supply and ground of a GPS chart plotter to be
used is different from that of the radio, connect the signal ground wire of the GPS chart plotter to
the ground terminal (GND) on the rear panel of the radio.
38400 Baud Connections
GPS Chart Plotter Radio Wires
Gray: NMEA OUT (+)
Brown: NMEA OUT (−)
Yellow: NMEA-HS OUT (+)
White: NMEA-HS OUT (−)
Blue: NMEA IN (+)
Green: NMEA IN (−)
Plotter Connection
No Connection
No Connection
NMEA IN (+)
No Connection
NMEA IN (−)
No Connection
External GPS Antenna
SCU-31 (optional)
Wire Color/Description Connection Examples
BLUE - NMEA GPS Input (+)
No connection
GREEN - NMEA GPS Input (−)
No connection
GRAY - NMEA DSC Output (+) NMEA (+) input of GPS*
1
BROWN - NMEA DSC Output (−) NMEA (−) input of GPS*
1
YELLOW - AIS Data Output (+)
No connection*
2
WHITE - AIS Data Output (−)
No connection* 2
*1: The GPS chart plotter Com Port must be setup to 38400 baud (HS) to receive DSC and AIS sentences
from the GX6000
(Gray and Brown wires).
*2:
The GX6000
always outputs NMEA 0183-HS VDM sentence at 38400.
Note
: Some GPS chart plotters have a single wire for NMEA signal ground. In such a case connect the NMEA
input (−) to the GPS chart plotter’s single NMEA signal ground wire, and leave the NMEA output (−) open. In case
the assignment of power supply and ground of a GPS chart plotter to be used is different from that of the radio,
connect the signal ground wire of the GPS chart plotter to the ground terminal (GND) on the rear panel of the radio.