Always ensure the machine is completely switched off and isolated
before carrying out any adjustment and maintenance work.
The Scouring Section
The Heel Breaster
The Heel Breaster is mounted on a
bayonet fitting. To remove hold the
breaster shaft with the tommy bar (in
kit), loosen and remove the left-hand
binding screw and withdraw breaster.
Replace the breaster by the same
method.
Hole for tommy bar as shown (1)
Scouring bands
Firstly, on models which have a front mounted Naumkeag
motor, make sure this motor is lowered before opening
the front machine flap.
To change the bands unlock and lift the front cover and
secure by means if the flap prop (2). Pull tension levers
(3) forward. Slip the old band off the rear driving pulley
and front contact wheels (4). Replace bands ensuring it
will run in the same direction as arrow printed on the
inside of the band. Re-tension the bands by
releasing the tension levers.
2
Lower the front cover and
re-lock. Spin bands by hand to
ensure that there is approximate
band alignment. Switch on the
machine and adjust band
alignment by means of the
adjusting screws with the large
tommy bar provided.
1
3
4
4
17
