background image

2

)

 F

LUSH

 M

OUNT

 I

NSTALLATION

1. Remove the 

MLS-300i

 

from the bracket by removing the

two Mounting Bracket Knobs, then remove the rear case
of the 

MLS-300i

 

from the main body by removing the

four screws (Figure 4).

2. Assemble the supplied M4x50 Screw, Nut, and Washer as

the Figure 5.

3. Use the supplied template to mark the location where the

round hole is to be cut. Confirm the space behind the dash
or panel is deep enough to accommodate the 

MLS-300i

(at least 2.8 inch (70 mm) deep).

4. Cut out the round hole (one large hole and four small

mounting holes) and inset the 

MLS-300i

 from the front

side.

5. Referring to Figure 6, pass through the four M4x50 Screws

(with Nut and Washer) into the mounting holes on the panel
from the back side and turn the M4x50 Screws five times.

6. Turn the four Nuts to adjust the tension so that the 

MLS-

300i

 is tight against the mounting surface.

7. Route and secure the connection cable from the 

MLS-300i

to the 

VLH-3000

 Loud Hailer. Connect the WHITE wire

of the connection cable to the “positive (+) intercom
speaker output,” the shield of the connection cable to the
“negative (–) intercom speaker,” and the YELLOW wire
of the connection cable to the “push to alert” terminal (Fig-
ure 3).

O

PERATION

 

(

PTA F

EATURE

)

To call the 

VLH-3000

, press the 

PTA

 button. A calling beep

will be heard on the 

VLH-3000

 with an indication of the in-

tercom station (

IC1

 or 

IC2

).

R

EPLACEMENT

 P

ARTS

PTA (Push To Alert) Button

 (Black):

RA0831900

PTA (Push To Alert) Button

 (White):

RA0815300

Mounting Bracket

 (Black):

RA0653900

Mounting Bracket

 (White):

RA0653800

Mounting Bracket Knobs

 (Black):

RA045910A

Mounting Bracket Knobs

 (White):

RA043770A

Mounting Bracket mounting hardware

:

U9900147

S

PECIFICATIONS

Speaker Impedance

:

Maximum Power Input

:

10 W

Connection Cable Length

: 6.5 feet (2 m)

Figure 4

Figure 6

Figure 5

Wall thi 1 inch

Washer

Nut

M4x50 Screw

φ

TEMPLATE for the MLS-300i

Use this template to mark the location
where the round hole for the flush
mount is to be cut.

106 mm

95 

φ

106 mm

Reviews: