ASSEMBLY & INSTALLATION INSTRUCTIONS
IMAGE #1
1. After unpacking the PTA find the switch arm and
assemble it to the PTA using the 1/4” x 1 1/4” bolt
and locknut. (note switch arm can be on the right or
left side depending on how the unit was ordered) See
image #1.
2. Locate the battery and place it into the battery pan.
Plug in the battery. .See Page #8
3. The PTA must be raised a few inches for access to
the securing holes. Push the control switch located in
the end of arm rest up until PTA raises 4 or 5 inches.
4. The PTA is secured to the existing toilet. Remove
the toilet seat from the existing toilet. Keep the bolts
and nuts.
5. Secure existing toilet seat to top holes on the PTA
using the bolts and nuts you removed from your
existing toilet seat. CAUTION: Some bolts need to
be cut off, so when the unit is in the complete down
position they don’t hit the PTA frame or toilet.
See image #2.
6. Place gasket from the PTA package over existing
commode holes. Position PTA over gasket and se-
cure using 3/8”x 2-1/2” carriage bolts (#31) and wing
nuts (#32). That are provided with the PTA.
7. Adjust the leg pads under the front of the PTA to
touch the floor and firmly support the PTA.
8. The PTA is raised by pushing control switch
(located in the end of the arm rest) up until desired
height is reached. To lower push switch down.
9. Adjust tilt of toilet seat arms with two set screws
on support arm brackets.
10. Battery life is 3-5 years on average. See pg. 8
for battery information
IMAGE #2
12. Depending on the stool height adjust the leg pads
for height. (longer leg pads are available on request.)
11. Serial number tag is located on the inside of the
switch arm, under padding.
Page 7