Stanbridges Quakewave, Instruction Manual

Page: 36 / 37

The Splash Water Resistant Brushed Speed Controller (ESC)
(Item No.: E910,E920 and E930)
TECHNICAL DATA:

Output: 6V(Min.), 7.2V(Normal), 8.4V(Max.)

Current: 60A (Normal), 80A (Max.), 120A/5S

+5V Current: 1A (Normal), 2A/10S (Peak)

Resistance: 0.003 ohm

Motor Type: RC 540 /14T

SIZE/WEIGHT: 42*32*22mm, 51g

Battery Type: Ni-CD/Ni-MH/Li-Po
INSTALLATION:

Attach the speed controller (ESC) to the vehicle, e.g. with a piece of hook-and-loop tape or double-faced
adhesive tape. The speed controller (ESC) should be installed in the car as far as possible away from the
receiver.

The power switch of the speed controller (ESC) should be attached with no breakage and locked with the
screws onto the car.
OPERATION:
Note: When switching the speed controller on, for safety reasons please ensure the vehicle is off the ground.
1) Make sure the speed controller is switched off and then connect a charged battery to the speed controller
2) Switch on the radio controller.
SET-UP:
1) Make sure the speed controller is OFF.
2) Press and hold SEL button, and not to release it
until the speed controller is switched on.
3) The red LED becoming flashing regularly , the speed
controller enters SET-UP menu.
The items, listed as follows, can be calibrated in sequence.
Pull the trigger (on the radio controller) back as shown in the picture ,
ESC permitting motors to work and the car goes forwards.
Push the trigger outwards to brake.
Return the trigger( on the radio controller) back to Centre assuming a
break time for ESC , and push the trigger at a second time to enable
the car to go backwards.