Stamina SlimStrider 360 55-9162, Owner'S Manual

Page: 9 / 24

ASSEMBLY INSTRUCTIONS
9
STEP 4:
There is an “R” decal on the
RIGHT FRONT SWING ARM(6),
and an “L” decal on the
LEFT FRONT SWING ARM(4).
Hook the LEFT
FRONT SWING ARM(4)
and
LEFT REAR SWING ARM(5)
onto the
PIVOTING JOINTS(16)
on the left side of the
UPRIGHT(1).
STEP 6
Secure the
LEFT FRONT SWING ARM(4)
to the PIVOTING JOINT
(16)
with the
SUPPORT BRACKET(11),
two BUTTON HEAD BOLTS
(M8x1.25x4 0 mm)(35),
and two
NYLOCK NUTS(M8x1.25)(43).
Be sure
the
BUTTON HEAD BOLTS(M8x1.25x4 0 mm)(35)
are facing in.
Repeat the above assembly steps for the right side.
NOTE: Check the PIVOTING JOINTS(16) area. If t
here is any exce
ss
grease, please wipe it off with an absorbent cloth.
STEP 5
Secure the
LEFT REAR SWING ARM(5)
to the
PIVOTING JOINT(16)
with the
SUPPORT BRACKET(11),
two BUTTON
HEAD BOLTS(M8x1.25x4 0 mm)(35),
and
two
NYLOCK NUTS(M8x1.25)(43).
L
R
Swing Arm
Assembly
Protection Cap
Protection Caps
A.
NOTE:
Refer to illustration A. The Protection Caps are used only for
protection during shipment. Remove and discard the Protection
Caps which are covered in the ends of the Swing Arm Assembly.