ASSEMBLY INSTRUCTIONS
7
STEP 4
NOTE:
Thread the
RIGHT PEDAL(40)
onto the right side of the
CRANK(7)
as shown. Use a wrench to tighten
the pedal securely. Select the
RIGHT PEDAL STRAP(41)
which has
R
marked on the bottom side of the
strap. Snap the three hole end onto the inside edge of the
RIGHT PEDAL(40).
Snap the other end onto
the outside edge of the
RIGHT PEDAL(40)
with the
R
mark on the bottom of the
RIGHT PEDAL
STRAP(41).
Select adjustment holes which allow your foot to be easily removed from the pedals.
Use the same procedure to attach the
LEFT PEDAL(38)
onto the left side of the
CRANK(7)
and snap the
LEFT PEDAL STRAP(39)
onto the
LEFT PEDAL(38).
The
RIGHT PEDAL(40)
has
R
stamped on the end of the pedal shaft. The
RIGHT PEDAL(40)
has right hand threads and is tightened by turning clockwise. The
LEFT PEDAL(38)
has
L
stamped
on the end of the pedal shaft. The
LEFT PEDAL(38)
has left hand threads and is tightened by
turning counter clockwise.
STEP 3:
Attach the
SEAT(45)
onto the
SEAT POST(6)
with
NYLOCK NUTS(M8)(70)
and
LOCK
WASHERS(M8)(69).
Pull out the
SPRING PIN KNOB(44)
located on the
MAIN FRAME(1).
Then
insert the
SEAT POST(6)
into the
MAIN FRAME(1)
and secure with the
SPRING PIN KNOB(44).
NOTE:
It may be necessary to unscrew the
SPRING PIN KNOB(44)
slightly to insert the
SEAT POST(6).
Make sure that the pin on the
SPRING PIN KNOB(44)
is inserted into one of the holes in the
SEAT POST(6).
The
SPRING PIN KNOB(44)
should be screwed in tight to make the
SEAT POST(6)
fit
securely in the
MAIN FRAME(1).
1.
2.
3.
