OPERATIONAL INSTRUCTIONS
GENERAL PRECAUTIONS
Do not use the
Therapy Inversion System
alone. Always have a helper available in case assistance is
needed in recovering from the decline position.
Make sure that the
FOAM PADS(16)
and
HEEL HOLDERS(19)
are holding your feet securely.
Make sure that the
HEIGHT ADJUSTMENT BEAM(12)
is properly set for your height.
Make sure that the
HEIGHT ADJUSTMENT BEAM(12)
is held securely by both the
SPRING PIN(22)
and the
SECURING KNOB(23).
Make sure that there is enough room for the bed to rotate completely.
1.
2.
3.
4.
5.
11
HEIGHT ADJUSTMENT
The
Therapy Inversion System
is a very sensitive balance device. It responds to very slight changes in
weight distribution. It is very important to make sure that the height adjustment is adjusted properly. Use the
following procedure to set the height adjustment and balance the
Therapy Inversion System.
Adjust the
NYLON STRAPS
to restrict
movement to approximately 15 degrees
beyond the horizontal position. The nylon
straps
should not allow the
Therapy
Inversion System
to go into the full inversion
position while you are setting the height
adjustment.
Loosen the
SECURING KNOB(23)
under the
MAIN FRAME(4).
Pull the
SPRING PIN(22)
and use the
SCALE DECAL(20)
to set the
HEIGHT
ADJUSTMENT BEAM(12).
Tighten the
SECURING KNOB(23).
Mount the machine.
Lock your ankles into the
FOAM PADS(16)
and
HEEL HOLDERS(19).
Lie back with your hands at your sides.
Slowly raise your hands to your chest.
1.
2.
3.
4.
5.
6.
7.
8.
9. If your feet are higher than your head, dismount and try a taller setting. If you do not rotate to a position
close to level, dismount and try a shorter setting.
NOTE:
The
Therapy Inversion System
should return to the upright position when your hands are below
your waist. If it does not, use a taller setting.
1.
2.
HANDRAILS
The
Therapy Inversion System
features a set of Handrails for added convenience and safety. The Handrails
are connected to the bed with linkages so that pulling on the Handrails will move the bed away from the
inverted position toward the upright position.
Pull the Handrails to pull yourself to the upright position from any degree of inversion. If you wish to
return to the upright position and the bed is not moving or moving too slowly, grasp and pull the Handrails
until you return to the upright position.
Grasp the Handrails to control the speed of inversion or stop the inversion.
WARNING:
Make sure that the Handrails are functioning properly before going into full inversion.
Summary of Contents for 55-1539A
Page 14: ...PRODUCT PARTS DRAWING BACK FRONT 14 ...
Page 18: ...NOTES 18 ...