OPERATIONAL INSTRUCTIONS
10
GENERAL PRECAUTIONS
Use the lowest holes in the
PIVOT ARMS(5)
until you become familiar with the
Gravity Inversion
Therapy Table.
Do not use the
Gravity Inversion Therapy Table
alone. Always have a helper available in case assistance
is needed in recovering from the decline position.
Make sure that the
HEEL HOLDERS(12)
and
FOAM PADS(31)
are holding your feet securely.
Make sure that the
HEIGHT ADJUSTMENT BEAM(6)
is properly set for your height.
Make sure that the
HEIGHT ADJUSTMENT BEAM(6)
is held securely by both the
LARGE SPRING
PIN(18)
and the
LOCKING KNOB(19).
Make sure that there is enough room for the bed to rotate completely.
1.
2.
3.
4.
5.
6.
THE HANDLEBARS
For added convenience, and safety, a set of
HANDLEBARS
has been added to the
Gravity Inversion
Therapy Table.
These
HANDLEBARS
are located at the top of the
REAR FRAME(2).
The
HANDLEBARS
are to help you return to the upright position from any degree of inversion. If you wish to return to the upright
position, and the bed is moving too slowly, or not moving at all, simply grab the
HANDLEBARS
and pull on
them until you return to the upright position.
HEIGHT ADJUSTMENT
The
Gravity Inversion Therapy Table
is a very sensitive balance device. It responds to very slight changes
in weight distribution. It is very important to make sure that the height adjustment is set properly. Use the
following procedure to set the height adjustment and balance the
Gravity Inversion Therapy Table.
Adjust the
NYLON STRAPS
to restrict
movement to approximately 15 degrees
beyond the horizontal position. The
nylon straps
should not allow the
Gravity
Inversion Therapy Table
to go into the full
inversion position while you are setting the
height adjustment.
Loosen the
LOCKING KNOB(19)
under the
MAIN FRAME(4).
Pull the
LARGE SPRING PIN(18)
and use
the
SCALE DECAL(16)
to set the
HEIGHT
ADJUSTMENT BEAM(6).
Tighten the
LOCKING KNOB(19).
Mount the machine.
Lock your ankles into the
HEEL HOLDERS
(12)
and
FOAM PADS(31).
Lie back with your hands at your sides.
Slowly raise your hands to your chest.
If your feet are higher than your head,
dismount and try a taller setting. If you do
not rotate to a position close to level,
dismount and try a shorter setting.
1.
2.
3.
4.
5.
6.
7.
8.
9.
The
Gravity Inversion Therapy Table
should return to the upright position when your hands are
below your waist. If it does not, use a taller setting.
Verify that adequate head clearance is available between the user's head and the floor before
using this inversion table. This is especially important for tall users.
NOTE:
1.
2.
Handlebars
Summary of Contents for 55-1532
Page 14: ...PRODUCT PARTS DRAWING BACK FRONT 14 ...
Page 17: ...NOTES 17 ...
