7
Operating
To start up the device, connect it to the mains. The device is immediately ready for operation.
This setting is only relevant if the device is working as Slave in a Master / Slave configuration
and is not controlled via DMX. In this operating mode, the device responds to the control sig‐
nals of the master device.
Establish all necessary connections and set DIP switch no. 10 to
[ON]
, all others to
[OFF]
to
enable the mode.
This setting is only relevant if the device is working in Stand Alone mode and is not controlled
via DMX.
To enable the sound-controlled mode, set all DIP switches to
[ON]
.
Starting the device
Operating mode ‘Master / Salve’
Operating mode ‘Sound to
Light’
Operating
stroboscope
26
Summary of Contents for Power Strobe 1500 DMX
