HIIT Bike
CONSOLE ASSEMBLY INSTRUCTIONS
For Installation assistance or missing parts, please call CORE Health & Fitness at 1(800) 503-1221
Document # 620-8582 Rev. B
PAGE 2 OF 2
STEP 4:
After installing the console, ensure that the unit type is set
for the appropriate model:
Power the console on by pressing the counter-clockwise arrow.
Press and hold the level up, level down, and clock buttons at the
same time for 3-5 seconds.
Use the down arrow to navigate to the 3rd page and press the clock
button to change between the following:
P1 “tread” - HIITMill and HIITMill X
P2 “bic1” - HIIT Bike
P3 “ergo” - HIIT UBE
P4 "Step" - Not Used Currently
P5 “bic2” - Airfit Bike
P6 none - Not Used Currently
Press the counter-clockwise arrow button to save the unit type.
STEP 3:
Use a 3mm allen key to secure the HIIT Console
to the mount using four (4) M5 x 14mm screws.
STEP 2:
Before mounting the console to the bike,
gently pull the data cable from the mast then connect
the end of the data cable to the console.
NOTE:
Be
sure to feed any slack cable back into the mast.
LR14 1.5V
STEP 1:
Use a #2 phillips screwdriver to remove the
locking screw securing the battery drawer inside
the console. Remove the battery drawer then
install two (2) LR14 1.5V batteries into the drawer.
Finally, reinsert the battery drawer and reinstall
the locking screw.
