Page 21
LCD OPENHUB CONSOLE
MAINTENANCE MODE - LCD
Maintenance Mode allows access to service and diagnostic information, as well as provides the ability to adjust
certain program default parameters. To enter Maintenance Mode:
1.
Press and hold the
,
and
keys together.
2.
A beep will sound and “MAINTENANCE MODE” will display momentarily in the Information Window.
3.
Release all keys. “SERIAL NO
#####
” will display in the Information Window.
The following keys are available in MAINTENANCE MODE:
Level Keys
Increase and Decrease LEVEL Keys:
Adjust the value of the
displayed parameter up and down, respectively, in increments of 1 unit.
These keys do not save the new value.
Numeric Keypad
Numeric Keypad:
Allows you to enter specific values for numeric
parameters. These keys do not save the new value.
OK Key
Updates (saves) the values of all parameters in non-volatile memory,
and exits Maintenance Mode.
NOTE:
To exit Maintenance Mode without saving any values or settings, press the QUICK START key.
A complete list of the items that you may display and change in Maintenance Mode:
Item
Min
Max
Default
Notes
SW VERSION
01.00
99.99
N/A
Display software version (set by factory)
LCB VERSION
01.01
99.99
N/A
Load Control Board software version
(set by factory)
SERIAL #
0
65535
N/A
Serial number (set by factory)
RUN HRS
0
65535
N/A
Total operating hours
MAINT HRS
0
9999
N/A
Total operating hours since last reset
FLOORS
0
65535
N/A
Total floors climbed
UNITS (ENGLISH/METRIC)
English
Metric
English
English = pounds, feet; Metric =
kilograms, meters
DEFAULT TIME (5-180)
5
180
120
Default time used by programs
WEIGHT (LBS) (50-350)
50
350
176
Default user weight used in calorie
calculations if not entered by user
INTENSITY (1-9)
1
9
1
Default starting level
AGE (5-99)
5
99
40
Default user age used if not entered by
user
