Stahls A2Z HEAT PRESS, Operating Manual, Page: 4 / 13

Initial Setup
Carefully follow the step-by-step instructions for best results:
• To avoid burns, do not touch the heated upper platen during use.
• Keep hands clear of the upper platen during platen lock down as the pressure may cause
injury.
• Press should be placed on a sturdy, level surface at least 76 cm L x 51 cm W x 24 cm H.
• Keep the work area clean, tidy and free of obstructions with enough space to swing the
press open.
• Connect the power cord into a properly grounded 240 volt electrical outlet with a minimum
16 amp rating.
• If necessary, a minimum ø 2,5mm², 16 amp extension cord is required.
Maintenance & Service
Your heat press requires minimal service to achieve a long, trouble-free life:
1 Clean exposed surfaces with a damp cloth to prevent dust buildup, which could lead to over-
heating.
2. All other maintenance and service should be performed by an authorized service representative.
Maintenance & Service
Moving the heat press is easiest with the handle in the lowered and locked position.
WARNING
WARNING
Disconnect the appliance from its power source during service or when replacing parts.
Allow heat press to cool before moving or storing.
OPERATING INSTRUCTIONS