127303 / 8003607300
2016-05-23·BA00·III·en·05
Transport and Storage
9
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Panel mounting devices
Series 8003/1
6
Transport and Storage
• Transport and store the device only in the original packaging.
• Store the device in a dry place (no condensation) and vibration-free.
• Do not drop the device.
7
Mounting and Installation
The device is approved for use in gas explosion hazardous areas of Zones 1 and 2 and
in safe areas.
DANGER
Explosion hazard due to installation without approved field enclosure!
Non-compliance results in severe or fatal injuries!
• If used in Zone 1, the device must be installed in an enclosure
that meets the requirements of IEC/EN 60079-11 and
IEC/EN 60079-7.
• If used in Zone 2, the device must be installed in an enclosure
that meets the requirements of IEC/EN 60079-15.
DANGER
Explosion hazard due to incorrect installation of the device!
Non-compliance results in severe or fatal injuries.
• Carry out installation strictly according to the instructions and
national safety and accident prevention regulations to maintain the
explosion protection.
• Select and install the electrical device so that explosion protection
is not affected due to external influences, i.e. pressure conditions,
chemical, mechanical, thermal and electric impact such as
vibration, humidity and corrosion (see IEC/EN 60079-14).
• The device must only be installed by trained qualified personnel
who is familiar with the relevant standards.
