Function and Device Design
6
127303 / 8003607300
2016-05-23·BA00·III·en·05
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Panel mounting devices
Series 8003/1
Maintenance, repair, commissioning
• Before commissioning, make sure that the device is not damaged.
• Work on the device, such as installation, maintenance, overhaul, repair, may only be
carried out by appropriately authorised and trained personnel.
• Perform only maintenance work or repair described in these operating instructions.
3.3
Modifications and Alterations
4
Function and Device Design
4.1
Function
Application range
The panel mounting devices are approved for use in hazardous areas of Zones 1 and 2.
The devices are available in 3 versions:
• Type 8003/1.1: with spring clamp terminal and connection chamber
• Type 8003/1.2: with spring clamp terminal
• Type 8003/1.3: with connection line and connection chamber
Types 8003/1.1 and 8003/1.3 are completely certified explosion-protected equipment.
They are suitable for installation on enclosure walls, electrical device covers, panels or
control cabinets.
Types 8003/1.2 are incomplete, explosion-protected electrical equipment suitable for
installation in enclosures of type of protection "increased safety" according to
IEC/EN 60079-7.
DANGER
Explosion hazard due to modifications and alterations to the device!
Non-compliance results in severe or fatal injuries.
• Do not modify or alter the device.
No liability or warranty for damage resulting from modifications and
alterations.
DANGER
Explosion hazard due to improper use!
Non-compliance results in severe or fatal injuries.
• Use the device only in accordance with the operating conditions
described in these operating instructions.
• Use the device only for the intended purpose specified in these
operating instructions.
