255118 / 815060300340
2017-04-19·BA00·III·en·01
Transport and storage
7
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Terminal box
Series G150/1
4
Transport and storage
Transport and store the device carefully and in accordance with the safety notes
(see chapter 3).
5
Product selection, project engineering and modification
When complying with the installation conditions and specifications on the type plate:
Check whether enough cable entries are provided. Drill additional holes if necessary;
see sections 5.1 to 5.2.
Equip terminals and, if necessary, mount built-in components; see section 5.4.
The methods mainly considered for modification are subsequently machining or equipping
the terminal box. In this case, the following possibilities are available:
• Additional through holes on the flange plate, either by R. STAHL or by the customer
(section 5.1)
• Additional through holes in the enclosure, either by R. STAHL or by the customer
(section 5.2)
• External attached components either by R. STAHL or by the customer (section 5.3)
• Internal built-in components either by R. STAHL or by the customer (section 5.4)
DANGER! Impairment of IP protection.
Non-compliance results in fatal or severe injuries.
Devices with enclosure hinges must be transported only with a transport lock.
DANGER! Impairment of IP protection.
Non-compliance results in fatal or severe injuries.
Only apply labels (on the outside) without drilling any additional holes.
Only create additional drilled holes specifically in accordance with the instructions
in the "Mounting" chapter. Consult R. STAHL in the event of deviations or
uncertainties.
Equip the enclosure only with equipment (e.g. cable entries, stopping plugs, drain
and breather valves) that is verifiably approved for use in operation.
Close any unused cable entries.
Seal all open drilled holes by means of suitable equipment.
Acceptance of work performed in-house must be carried out in accordance with national
regulations.
