218095/FX1560300010
2013-08-27·BA00·III·en·02
Installation
7
GRP Explosion Proof Visual
Signal 5 Joule
Series FX15
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
7.2
Installation Conditions
7.3
Assembling and Operating Position
- Select a suitable location with regard to the area to be covered by the FX15.
- The surface should be flat in the area of the fixings (See 7.1 for fastening dimensions)
and the material suitable to carry the weight of the FX15.
WARNING
Risk of electric shock!
Before opening the device, disconnect it from the power supply.
WARNING
No explosion protection if components are damaged or incorrectly
installed!
Operate the device only if it is not damaged.
If the thread is damaged, the device must be replaced immediately.
Take extreme care when handling the device and internal components.
Particular care is needed when accessing the PCB for installation.
Exposed joint surfaces must be protected and not have contact with dust
or dirt, or be knocked against any object.
The end flanges must be fitted squarely and on no account is force to be
used.
The flange must not be hammered, levered with a metal instrument or the
fixing screws used to pull down the flange.
With care and patience, it will be found that the flange enters the body
without difficulty.
Install the device only in a clean and dry operating environment.
NOTE
Check the following:
Do you have the correct device to satisfy the system specification?
Are the gas group and temperature range of the product suitable for the
intended application?
Is the supply voltage correct?
Is the strobe the correct colour?
Is a suitable mounting location available?
WARNING
Incorrectly installed components!
Explosion protection cannot be guaranteed any more if the components
are incorrectly installed.
When terminal sleeves are fitted, they must be gas-tight and applied with
a suitable tool.
