Mounting and Installation
10
200089 / 9170612310
2020-04-30·BA00·III·en·09
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Switching repeater
Series 9170/.1
6.1.4 Mounting / Dismounting on pac-Carrier
See operating instructions for pac-Carrier Type 9195.
6.1.5 Mounting / Dismounting pluggable Terminals
All devices are equipped with pluggable terminals.
Mounting
Insert the terminal into the device until the terminal engages.
Dismounting
10859E00
Position the screwdriver behind the terminal.
Push out the terminal.
6.2
Installation
6.2.1 Electrical Connections / Schematic Diagram
See device labelling.
6.2.2 Connection of Supply
Connect the main and auxiliary power according to the following scheme
(see table and chapter 15.1).
Operation under difficult conditions, in particular on ships, requires additional
measures to be taken for correct installation, depending on the operating location.
Further information and instructions on this can be obtained from your regional sales
contact upon request.
DANGER! Explosion hazard due to no safeguarding or incorrect safeguarding of the
auxiliary power!
Non-compliance may result in serious or even fatal injuries.
Protect the device with an electrical back-up fuse, e.g. T 2A H.
Ensure sufficient short-circuit current in the system
(e.g. 24 V DC power supply. with a nominal output current of 4 A or higher).
Device type
Type of supply
Connection
9170/.1-1.-1.
Direct supply of the device via
24 V connection
Green terminal "7+" and "9-"
Supply via pac-Bus
pac-Bus terminal "1+" and "2-"
9170/.1-1.-21
Direct supply of the device via
230 V connection
Green terminal "L" and "N"
Supply not possible via pac-Bus
–
Summary of Contents for 9170 1 Series
Page 41: ......
