251986 / 6118602300
2019-03-07·BA00·III·en·03
Maintenance and repair
27
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Compact Sheet-steel
Emergency Light Fitting
Series 6118/1
Further error indications will be reset directly after troubleshooting.
If the error cannot be eliminated using the mentioned procedures:
• Contact R. STAHL Schaltgeräte GmbH.
For fast processing, have the following information ready:
• Type and serial number of the device
• Purchase information
• Error description
• Intended use (in particular input / output wiring)
11
Maintenance and repair
11.1 Maintenance
• Consult the relevant national regulations to determine the type and extent of
inspections.
• Adapt inspection intervals to the operating conditions.
During maintenance of the device, check at least:
• the tight fit of the clamping screws holding the cables,
• if the device enclosure and / or protective enclosure have cracks or other visible signs
of damage,
• the seals for ageing and damage,
• the device inside and outside for pollution and clean it if neccessary,
• compliance with the permissible temperatures (according to EN 60079),
• if the device is used in accordance with its designated use.
Resetting the capacity error (blinking red).
• Replace the battery.
Automatic:
• A continuous operation test is carried out automatically after 36 hours.
• The error will be reset once the test has been passed successfully.
Manual:
• Actuate the switch in the battery case for 5 seconds.
• Release the switch.
• Actuate the switch twice within 10 seconds for a duration of 2 seconds.
• Close the battery case.
• Resetting of the capacity error will be indicated on the LED display for
5 seconds by blinking red/green.
• The error is reset.
WARNING
Risk of electric shock or malfunctioning of the device due to unauthorized
work!
Non-compliance can result in severe injuries and material damage.
• Work performed on the device must only be carried out by appropriately
authorized and qualified electricians.
• To be carried out as per EN60079-17 and as per EN60079-19.
Summary of Contents for 6118/1 Series
Page 31: ......
