Stahl 130665, Operating Instructions Manual, Page: 28 / 32

Installation, Operation & Maintenance Sheet
14 8040606300
S-BA-8040-en-02-15/06/2007
Control and signal station
8040
80 406 10 30 0 2 October 13, 2006
INSTALLATION OPERATION
& MAINTENANCE SHEET
R. STAHL, INC.
45 Northwestern Drive
Salem, NH 03079-4809
Tel: 800-782-4357 FAX: 603-870-9290
E-mail: sales@rstahl.com
Website: www.rstahl.com
4.3 Installations of Cable Connectors:
4.3.1
When field installing connectors, use the pro-
vided conductive ground metal plates.
4.3.2
Align the ground plate inside the enclosure so
that the threaded hole is centered with the
hole in the enclosure.
4.3.3
Insert the connector through the sealing ring
and screw the connector into the ground plate
inside the enclosure.
4.3.4
Tighten the connector so that the sealing ring
is pressed evenly against the enclosure.
4.3.5
Tighten the set screw on the metal plate to
prevent the connector from loosening.
4.3.6
In case of through wiring the two ground
plates need to be bonded with jumper wire
since the FRP enclosures are non-metallic.
6.
Connect conductors to the component termi-
nals (capacity: 12 AWG or 2.5 mm
2 ).
Conductor insulation must reach to the termi-
nals. Tighten all terminals to 18 in.-lb. (includ-
ing those unused) and secure components on
mounting rail.
7.
Perform a continuity check.
8.
Replace the enclosure cover ensuring
alignment between actuators and internal
components. Actuate the switch and/or
pushbuttons to check for free operation.
9.
Energize the supply circuit and test the
system.
ENCLOSURE WALL
CONNECTOR
SEALING RING
METAL PLATE WITH
THREADED HOLE
SET SCREW
TERMINAL
GROUND WIRE
Size
1/2"
3/4"
MC / TEK Cable Connectors and Sealing RIngs
Size Ordering Code
1/2" PD-E-4-0-29-00
3/4" PD-E-4-0-30-00
Non-metallic
NPT Close-up Plugs
5. Approved Connector Hardware:
Sealing Ring
Ordering Code
NCS1
NCS2
MCR Series Connector
Ordering Code
MCR050
MCR075
Note:
The nature of these instructions is only informative and
does not cover all of the details, variations or combina-
tions in which this equipment may be used, its storage,
delivery, installation, safe operation and maintenance.
Since conditions of use of the product are outside of the
care, custody and control of the manufacturer, the pur-
chaser should determine the suitability of the product for
his intended use, and assumes all risk and liability what-
soever in connection therewith.