Colors and gobos
Maintenance
In order to ensure the fixture working well, maintain the cleanness of fixture is very necessary. It should be clean once every 30 days a er
cooling the fans. Internal and external op cal lens, reflector and coa ng color filter cleaning must be carried out periodically to op mize the
output light efficiency. Do not use any contains chemical solvent cleaning coa ng color filter
In order to maintain the gobo wheel smooth rota on and smooth movement, it is suggested to add grease for the rota on gobo wheel
every two months. Should use good quality grease.
When the lens have fracture and other damage, it should be replaced in me. when the fixture can't start to run, please check if the fuse of
power supply is burnout, if it is burnout please install the fi ed corresponding specifica on fuse with 5A / 250V. Note it must use the same
specifica ons fuse. The is installed with overhea ng protec on device, when it is overheat, the overhea ng protec on device will
automa cally cut off power supply. Please check whether the fan running, whether the fan and fan nets have dust jam, find troubleshoo ng
before working. But note that a qualified technicians can do the repair work.
Please do not use alcohol and other organic solvents to wipe housing, lest cause damage.
Cleaning the fixture depending on the opera ng frequency of fixture and the surrounding environment. Clean with a so cloth and cleaning
products for glass, suggest to clean the external op cal system at least once every 30 days , clean the internal op cal system at least once
every 30/60 days.
General troubleshooting
Phenomenon
Solu on
Fixture can not start to work
1. Check if the power fuse burnout
Fixture light normally, but no responding to
the DMX controller
2. Check if the XLR signal cable was damaged
1. Check if the DMX start address is correct
Fixture work intermi ently
Check if the fan work well, Whether dust blocked fan and fan
nets
Dark light, brightness decreases obviously
1. Check whether the internal and external op cal system
clean
Beam is not pure (have a halo
）
Clean the dust and oil of bulb, lens and other parts
The beam distor on serious
2. Clean the dust or oil of lens
1. Check whether the lens is broken
