• Stadler Form refuses all liability for loss or damage which arises as a result
of failure to follow these operating instructions.
• The appliance is only to be used in the home for the purposes described
in these instructions. Unauthorised use and technical modifications to the
appliance can lead to danger to life and health.
• Never submerge the unit in water (danger of short circuiting).
• Never run a defective unit (e.g. supply cord).
• Never touch energized parts.
• Only connect the cable to alternating current. Observe the voltage infor-
mation given on the appliance. Do not use extension cords.
• The heater must not be located directly below a socket-outlet.
• Do not open the appliance (repairs only by service agents).
• Do not run the power cord over sharp edges and make sure that it does
not get trapped. Do not pull the plug from the socket with wet hands or by
holding on to the power cord.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• Please make sure that the used socket remains accessible.
• Do not run the heater on an uneven or soft surface.
• CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer.
• WARNING: In order to avoid overheating, do not cover the air inlet or air
outlet – fire hazard!
• Do not use the heater in small rooms (below 4 m
2
in size), in explosive envi-
ronment, or for drying laundry.
• Do not touch the front part of the appliance, it might reach hot tempera-
ture.
• Use the heater only under supervision.
• Do not insert any object and/or finger into the openings of the heater.
• To extinguish burning appliances only use fire blankets
.
Setting up / operation
Note:
Make sure that there is always sufficient space between the appli-
ance and the wall or other large objects (> 50 cm). The air flow must not
be blocked by objects of any kind. If Anna big is set up in a bathroom, keep
a safety distance of at least 100 cm to showers, bathtubs, water faucets,
washbasins, etc.
1. Having set up Anna big in the desired position connect the cable (1) to the
household supply socket.
2. First, push the main switch for power supply (4) on the back of the ap-
pliance.
3. Switch on the appliance by pressing the On/Off button (6). The target
temperature appears on the display.
4. The target temperature can be changed from 0 °C (cooling mode) to
35 °C or maximum «Hi» over the right control panel (8) «Temperature».
The heating mode is active from 1 ° – 35 °C & «Hi». The digit flashes in
configuration mode. Pushing the «+» button increases the target tem-
•
If the supply cord is damaged, it must be replaced by the manufacturer,
or its service agent, or a qualified person in order to avoid a hazard.
