PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
OPENING THE SAFE USING
YOUR COMBINATION
1.
2.
Press the Reset Button (5) located inside the safe.
Two “beeps” will sound.
Enter your combination using the buttons. If 2
“beeps” sounds and the green light goes on, the door
will open. If an incorrect combination is entered 4
short “beeps” will sound.
Example: (RIGHT) - (LEFT) - (CENTER) -
(LEFT) - (RIGHT)
Enter your own 3-8 button combination by
pressing any combination of the 3 buttons.
NOTE: A “beep” will sound when the button is
successfully pushed.
3.
Press the Reset Button again. After two
“beeps” your new combination is recorded.
NOTE: If you enter a wrong combination 3 times,
the control pad will lock out for 5 minutes.
To close the safe, push the door closed until locked.
Reset Button
SELECTING A LOCATION
40286-1307
3
18
• For security you must program your own
combination after opening the safe.
• Record this new combination on this form or
store your combination on our secure website at
www.stack-on.com under Service. If you write
down your combination you must keep this
information in a secure place, away from
children, not inside the safe.
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
The safe must be mounted to a shelf. For optimal
safety and security, the safe should be installed in
an isolated, dry and secure area.
