STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
The safe must be secured to the mounting
bracket. The safe installed in the mounting
bracket must be mounted to a wall or solid
surface. For optimal safety and security, the
safe should be installed in an isolated, dry
and secure area.
SECURING THE SAFE
SELECTING A LOCATION
NOTE:
This safe must always be secured in
the mounting bracket and mounted to a wall
or solid surface. Failure to do so will
compromise the safety and security of
the safe.
Secure the mounting bracket to wall studs
using the pre-drilled mounting holes in the
bracket and hardware provided.
NOTE ON LOCKING THE SAFE:
The
mounting bracket needs to be in an upright
position, as shown in figure 3, for the locking
mechanism to function properly. Failure to
mount the safe in the correct upright position
will compromise the safety and security of
the safe.
NOTE:
The mounting bracket must be
secured to a wall stud on one side of the
bracket in the top and bottom holes so that it
is anchored to the wall stud in two locations.
Wall anchors should be used on the other
side. The bracket should be secured in 4
locations. Use the hardware provided or
consult your hardware retailer for fastening
hardware for your particular mounting
surfaces. After the mounting bracket is
secured you must secure the safe to the
bracket to insure the optimal safety and
security of the safe.
Place the mounting bracket in the desired
location and mark the mounting holes to be
used with a pencil. Move the mounting
bracket and drill the pilot holes for the
screws. For mounting to a wall stud, drill a
3/16” diameter pilot hole and attach the
bracket using the Lag screws and washers.
Place the safe back into the mounting
bracket and replace the 2 thumb nuts and
washers. Secure the holster compartment
in place, following the steps in Closing The
Safe section of these instructions. Close
and lock the safe
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
FIGURE 3
IMPORTANT
Keep keys and combination in a secure place, away
from children. Keep this record of your serial number
and combination in a secure place separate from your
safe. To order a replacement key set, follow the
instructions on the attached form.
Lag screws
Mounting
Bracket
40543-1511
6 16
