40546-1507
2
18
INSTALLING THE BATTERIES
NOTE: Do not mix old and new batteries. Do not
mix alkaline, standard or rechargeable batteries.
NOTE: If the batteries are low the indicator light will
flash blue when you start scanning. Replace with 4
new AA alkaline batteries as shown.
RECORDING FINGERPRINTS
When you first receive your safe there are no
recorded fingerprints. For security you must
record a fingerprint. Failure to do so will
compromise the safety and security of the safe.
You can record up to 20 different fingerprints
for opening the safe.
To record a fingerprint, first press the Reset Button on
the inside of the safe. The scanner will turn blue with
two beeps (if the sound is turned on) and the blue
light flashes twice, you will then record the same
finger three times as follows:
1. Press the scanner with the selected finger
until there is one beep (if the sound is turned
on) and the green light flashes once. Lift your
finger off the scanner.
2. Press the scanner for a second time with the
same finger (holding the finger in a slightly
different position) until there is one beep (if
the sound is turned on) and the green light
flashes once. Lift your finger off the scanner.
3. Press the scanner for a third time with the
same finger (holding the finger in a slightly
different position) until there are two beeps (if
the sound is turned on) and the green light
flashes twice. Lift your finger off the scanner.
If the red light flashes three times with three beeps (if
the sound is turned on) your fingerprint did not get
recorded and you will have to start over.
Your fingerprint is now recorded.
If you try entering more than 20 fingerprints, the red
light will flash 5 times and there will be 5 beeps (if the
sound is turned on).
For convenience, record several different fingers and
record the most used finger several times. Position
finger on scanner as shown below.
If your safe includes a shelf, remove it for better
access to the battery compartment. Push the battery
cover locking tab with a screwdriver to release the
cover. Install the (4) AA alkaline batteries as shown.
Replace the cover by inserting the rear tabs in the
slots and snapping the cover in place.
