40645-1511
2 12
To lock the safe, close the door and turn the knob to
the left to the 12:00 position.
LOCKING THE SAFE
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds after the fingerprint
is entered, wait a minimum of 6 seconds from the
time you have successfilly scanned your finger to
lock the safe. Also, when locking the safe, always
make sure the knob is turned completely to the
left to the 12:00 position. If the knob is not
turned to the 12:00 position during the locking
process, the locking mechanism will not lock.
When you first receive your safe there are no
recorded fingerprints. For security you must
record a fingerprint. Failure to do so will
compromise the safety and security of the safe.
You can record up to 20 different fingerprints
for opening the safe.
OPENING THE SAFE USING YOUR
FINGERPRINT
To record a fingerprint, first press the Reset Button on
the inside of the safe. The scanner will turn blue with
two beeps (if the sound is turned on) and the blue light
flashes twice, you will then record the same finger three
times as follows:
1. Press the scanner with the selected finger
until there is one beep (if the sound is turned
on) and the green light flashes once. Lift the
finger off the scanner.
2. Press the scanner for a second time with the
same finger (holding the finger in a slightly
different position) until there is one beep (if
the sound is turned on) and the green light
flashes once. Lift the finger off the scanner.
3. Press the scanner for a third time with the
same finger (holding the finger in a slightly
different position) until there are two beeps (if
the sound is turned on) and the green light
flashes twice. Lift the finger off the scanner.
Your fingerprint is now recorded.
If the red light flashes three times with three beeps (if
the sound is turned on) your fingerprint did not get
recorded and you will have to start over.
To open the safe, press the scanner with a recorded
finger. The blue light will come on with one beep (if
the sound is turned on) and the scan will begin.
If the green light flashes twice with 2 beeps (if the
sound is turned on), the scan has been accepted and
you will have 5 seconds to turn the handle to open
the door.
If the red light flashes once, the scanner did not read
your fingerprint and you must try again. If the red
light flashes 3 times, the scanner read your fingerprint
and did not accept it.
If there are 3 rejected scans, when your
fingerprint was read, and the red light flashes 5
times with 5 beeps (if the sound is turned on),
you will have an automatic lockout for 60
seconds before you can try a scan again. The
safe will beep one time (if the sound is turned
on) and the green light will flash once when the
lockout period is over.
If there is 1 more rejected scan where your
fingerprint was read and the red light flashes 5
times with 5 beeps(if the sound is turned on) you
will have an automatic lockout for 5 minutes
before you can try a scan again. The safe will beep
one time (if the sound is turned on) and the green
light will flash once when the lockout period is
over.
If you try entering more than 20 fingerprints, the red
light will flash 5 times and there will be 5 beeps (if the
sound is turned on).
For convenience, record several different fingers and
record the most used finger several times. Position
finger on scanner as shown below.
RECORDING FINGERPRINTS
