40536-1506
3
18
NOTE: Do not mix old and new batteries. Do not
mix alkaline, standard or rechargeable batteries.
This safe uses 4 - AA batteries. Under normal use,
batteries will last about 1 year.
NOTE: If the batteries are low, the yellow light will
flash when you start to enter your code.
To replace the batteries, open the battery
compartment on the back of the door by pushing the
tab in the direction of the arrow and install all new
batteries.
BATTERY REPLACEMENT
TURNING THE KEYPAD SOUND
OFF/ON
You can turn off the "Beep" sound of the keypad
by pressing the ... key.
To turn the "Beep" sound on, press the ....
key again.
SECURING THE SAFE
DRAWER MOUNTING
Select an appropriate sized drawer for your safe.
Place the safe in the drawer and try opening and
closing the safe and drawer. Do not attempt to
close the drawer with the safe open.
Place the safe in the desired drawer and mark the
mounting holes with a pencil. Remove the safe and
drill the pilot holes for the screws. Replace the safe
in the drawer and insert the screws through the
mounting holes and drawer bottom. For maximum
security, use 2 mounting screws. Secure the screw
by tightening the Nylock nut on the screws.
(Figure 1)
Figure 1
SELECTING A LOCATION
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
This safe must be mounted into a drawer
(PDS-1500) or into a drawer or the wall
(PDS-1505). For optimal safety and security, the
safe should be installed in an isolated, dry and
secure area.
NOTE: This safe must be mounted into a drawer
(PDS-1500) or into a drawer or the wall
(PDS-1505). Failure to do so will compromise
the safety and security of the safe.
Your safe comes with the "Beep" sound turned on.
