STACK-ON PRODUCTS CO.
P.O. BOX 489, WAUCONDA, IL 60084
SECURING THE CASE WITH THE CABLE
Reset Button
CLEARING THE MEMORY OF ALL
RECORDED FINGERPRINTS
NOTE: After you delete all the recorded
fingerprints, your safe will open by pressing the
START button (2). For security you must record
your fingerprint so the safe will read only the
recorded fingerprints.
When you replace the batteries the recorded
fingerprints will not be erased.
Press and hold the Reset Button (6) and then press
the START button (2). When there are 2 “beeps”
and the red light flashes, all the fingerprints have
been deleted.
START button
IMPORTANT
Keep keys in a secure place, away from children. Keep this
record of your serial number in a secure place separate from
your case. To order a replacement key set, follow the
instructions on the attached form.
40291-1307
4
18
To secure the case to a fixed object, loop the cable
around the object and place the cable’s small end into
the notch on the side of the case. Locking the case
will secure the cable end in the case.
For optimal performance, the case should be installed
in an isolated, dry and secure area
NOTE: This case is designed to be secured with a
cable that is attached to a fixed object. Failure to
to do so will compromise the safety and security
of the case.
THE CASE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
NOTE ON LOCKING THE CASE: The case
needs to be in an upright position, as shown in
figure 1, for optimum performance. Failure to
store the case in the correct upright position will
compromise the safety and security of the case.
NOTE: This unit is not an approved California
Department of of Justice firearm safety device.
Figure 1
