• For security you must program your own
combination after opening the case.
• Record this new combination on this form or
store your combination on our secure website at
www.stack-on.com under Customer Service. If
you write down your combination you must keep
this information in a secure place, away from
children, not inside the safe.
PROGRAMMING YOUR OWN
ELECTRONIC COMBINATION
Enter your combination using the buttons. The
buttons will light up green and there will be one
"beep"(if the sound is turned on) for every
entry. If you entered the correct combination,
the buttons will flash green and the door will
open. If the combination is incorrect the case
will beep 3 times (if the sound is turned on)
and the red light will flash 3 times.
NOTE: You will have 2 seconds between
individual entries before the case assumes
you have entered your complete
combination.
If an incorrect security code is entered 3 times
the safe will beep 5 times (if the sound is turned
on) and the red light will flash 5 times resulting
in the case being automatically locked out for
60 seconds before you can try your code again.
The case will beep one time (if the sound is
turned on) and the green light will flash once
when the lockout period is over.
If the incorrect security code is entered 1
additional time the case will beep 5 times (if the
sound is turned on) and the red light will flash 5
times resulting in the case being automatically
locked out for 5 minutes before the code can be
tried again. The case will beep one time (if the
sound is turned on) and the green light will
flash once when the lockout period is over.
To close the case, push the lid closed until locked.
OPENING THE SAFE USING
YOUR COMBINATION
1.
2.
3.
Example: (RIGHT) - (LEFT) -
(CENTER) - (LEFT) - (RIGHT)
Press the Reset Button (3) located inside the
safe. Two “beeps” will sound (if the sound is
turned on) and all 3 buttons will flash blue
twice. You will have 5 seconds to begin
entering your combination or you will have to
start over.
Enter your own 3-8 button combination by
pressing any combination of the 3 buttons.
For Each combination entry a “beep” will
sound (if the sound is turned on) and all the
buttons will light up green. If you delay more
than 5 seconds between entries there will be 2
beeps (if the sound is turned on) and 2 red
flashes and you will have to start over from step
2. After you have finished entering your
combination, you will have 5 seconds to press
the Reset Button to record your new
combination or you will have to start over from
step 2.
When you press the Reset Button to record
your new combination, there will be two
“beeps” (if the sound is turned on) and all 3
buttons flash blue twice, indicating your new
combination has been recorded.
To confirm your combination was entered
correctly, turn the key to the locked position
(the lid may remain open) and follow the
instructions in the “OPENING THE SAFE
USING YOUR COMBINATION” section.
If the combination you entered does not
activate the locking mechanism, you will need
to go back to step 1 in this section.
4.
40656-1512
3 12
