40427-1311
1 21
Instructions
BC-18-MB-E-S
BC-24-MB-E-S
BC-40-MB-E-S
WARNING
Tip Over Hazard
A child or adult can tip the safe and be
killed or seriously injured.
Failure to secure the safe as shown in
these instructions can result in death or
serious injury to children and adults.
Children should not play with or around
the safe at any time.
• Record the serial number from the tag on the
back of the safe or from the tag on the front
bottom corner of the safe.
IMPORTANT
• Keep keys and combination in a secure place
away from children.
• Do not store the back up key, your combination
or this document in the safe.
• Do not move this safe using its handle. The
handle should only be used for opening and
closing the door of the safe.
Serial #
Combination #
• Do not store electronic media, computer disks,
audio-visual media or photographic negatives in
this safe. This material will not survive the rated
internal temperature of the safe. This material
may be damaged or destroyed.
NOTE: You can store your Key #, Serial # and
Combination on Stack-On’s SECURE web site –
www.stack-on.com under Customer Service.
Storing your Key # or Combination will provide instant
access to this important information should you ever
lose your keys or your combination.
Only you will have access to this information.
BATTERY INSTALLATION
You must first install the battery which is located in the
front protective styrofoam
NOTE: When changing the battery, always hold the
battery connecting cap while disconnecting or attaching
the battery. Do not pull on the wires. Doing this could
cause the power supply to become disconnected from
the lock.
This safe uses one 9V alkaline battery. Under normal
use the batteries will last about 1 year.
When the battery is low and you press a button on the
keypad, a red light will come on warning you that the
battery is low.
To test the batteries, enter your security code. If the
batteries are low the red light will come on momentarily.
To replace the battery, remove the cover by pressing the
tab and turning the cover as shown in the illustration.
Replace the old battery and screw the cover back in
place.
Hardware Included:
(2) M10x70 Lag screws
(2) washers
(2) plastic anchors
Tools required:
drill
7/16” drill bit
3/8” drill bit
17mm socket wrench
Phillips screwdriver.
TAB
• Warning: Keep your safe closed and locked at
all times when not in use. Children could
accidentally be locked inside the safe.