stabo xm 3003e, Operating Instructions Manual

Page: 19 / 57

Installation
Installation in the motor vehicle
a) Please consider the instructions of your automobile manufacturer.
b) Make sure that all cables and connecting lines are laid in the
motor vehicle without any problems such that the vehicle operation
is not impaired. Do not install the cables near the heating system!
c) For installing your radio set at the appropriate position (see
figure), use the mounting device (1) and the tapping screws (2)
(drill hole diameter: 3.2 mm). Prior to drilling, make sure not to
damage any cables of the electric system in the car ! The mounting
device should be installed at an appropriate place providing a rigid,
reliable and almost vibrationless positioning of the radio set.
d) Choose a place for the microphone attachment such that the
microphone is always within reach. Remember that its microphone
cord must not interfere with the control elements of the vehicle.
Note: If the space for installing the radio set is so very restricted
that the loudspeaker radiation (at the bottom of the radio set) is
impaired, we recommend you to install an external mobile speaker
available as stabo accessory. This speaker is connected to the
EXT.SP jack (C) situated at the back side of the radio set. When
connecting the external speaker, the internal loudspeaker is auto-
matically deactivated.
19