4
T H E L E A D E R I N A N I M A L C O M F O R T
LASTING
COMFORT
FOR LASTING HEALTH
Cut the cover along the chalk-line.
5.
Pre-drill the plastic strips every 6” (15cm) as this
will make it easier to install the strips. Drill the
holes in the following pattern:
Measure the length of the wall, then cut the
plastic strip. This is best done by scoring one side
of the strip with a knife, then snap the strip
backwards.
6.
Place the cover against the wall and have a
helper hold it in place.
Hold it so that there is 6” (15cm) of extra material
on each side.
Anchor the bottom of the cover to the wall with
screws and the plastic strip.
7.
Using adhesive, tack the first layer of foam to the
wall (3/4”(2cm)-1 layer of foam, 1.5”(4cm)-2 layers
of foam). If you are installing the double layer,
stagger the foam pieces so the seams are not in top
of each other.
You may also use temporary screws with large
washers to tack Stable Wall pads to the wall. These
fasteners
MUST
be removed prior to Step 9, as
they may
PUNCTURE
the top cover. Damage from
these fasteners is
NOT
covered by Stable Wall
warranty.
8.