To change the threshold to another value (6 V, 10 V, 13 V or 17 V), R0 must be removed and a solder bridge must
be added on the selected OVP voltage.
2.5
USB Type-C D+/D- connections
expansion board bottom side, D+/D- lines from USB Type-C CN1 are connected to
development board thanks to R8 and R9 zero Ohm resistors. These lines
can be used for USB BC 1.2 check and data transmission.
There is no USB data on the
but USB BC 1.2 check can be done thanks to
PA4 (CN7 – 32) and PA5 (CN10 – 11): zero Ohm resistors R8 and R9 must be unsoldered and zero Ohm
resistors must be soldered on R10 and R11 footprints.
UM2668
USB Type-C D+/D- connections
UM2668
-
Rev 2
page 5/19
