ST X-NUCLEO-OUT15A1, Getting Started

Page: 4 / 20

1.1.2 Power section
The power section involves the power supply voltage (CN1, pins 4 and 5 for VCC, pin 3 for GND), load
connection (a load can be connected between pins CN1.1 and CN1.3 or CN1.2, and CN1.3; both output pins
are connected to the single output channel as shown in
Section 2 Schematic diagrams ) and electromagnetic
compatibility (EMC) protection.
Figure 3. X-NUCLEO-OUT15A1 expansion board: power section components
1. Overtemperature red LED
2. Overload red LED
3. IPS1025HF
4. Output channel - green LED
5. Output and power supply connector
For EMC:
•
the SM15T39CA transient voltage suppressor (TR1), enabled by closing J3, is placed between VCC and
GND tracks to protect the IPS1025HF against surge discharge on the supply rail path up to ±1 kV/2 Ω
coupling;
• in the common mode surge testing, two single-layer capacitors (C1 and C2 - not included) must be soldered
at the predisposed locations;
• the IPS1025HF output stages do not require additional EMC protections with respect to the IEC61000-4-2,
IEC61000-4-3, IEC61000-4-4, IEC61000-4-5, IEC61000-4-8 standards.
UM3036
Overview
UM3036 - Rev 1
page 4/20