ST STM8L1528-EVAL, User Manual, Page: 11 / 23

UM1000 Demonstration applications
Doc ID 17964 Rev 1 11/23
Figure 15. Warning Temperature display
The messages shown in Figure 15 is displayed on the LCD when the temperature goes
under the over limit low (TEMPERATURE_THYS: Hysteresis Temperature).
The user can configure the TOS and THYS thanks to a dedicated define values in the code.
By default the STM8L1528-EVAL demo is setting them to (see demo_thermometer.c file):
#define TEMPERATURE_THYS 31
#define TEMPERATURE_TOS 32
To exit this demo, press the joystick UP .
Note: Any hardware trouble on the board with the temperature sensor is detected by a test. In this
event, the message shown in
Figure 16 is displayed.
Figure 16.
Temperature sensor error
message
3.6 I
DD
measurement demo
The STM8L15x microcontroller features an ADC peripheral. It measures the I
DD
current in
Run mode by using the I
DD
measurement circuit available on the Root part number 1 board.
1. Select the IDD MEASUREMENT menu by pressing SEL from the main menu. The
message shown in Figure 17 is then displayed on the LCD screen.
Figure 17. I
DD
measurement message
2. Press SEL to display the current value of I
DD
in Run mode on the LCD screen (see
Figure 18 ). I
DD
value is periodically refreshed.
Figure 18. I
DD
Run mode message
Note: Make sure that the JP4 jumper is installed in the I
DD
position before running the I
DD
measurement demo.
Warning
Temp exceed 32C
ERR: SD Card
Initialization
IDD MEASUREMENT
Run Mode
IDD Run Mode
x.xxx mA
www.BDTIC.com/ST