ST STLINK-V3SEGT, User Manual

Page: 30 / 42

Software configuration UM2448
30/42 UM2448 Rev 5
11 Software configuration
11.1 Supporting toolchains (not exhaustive)
Table 17 gives a list of the first toolchain version supporting the STLINK-V3SET product.
Note: Some of the very first toolchain versions supporting the STLINK-V3SET (in runtime) may
not install the complete USB driver for STLINK-V3SET (especially the STLINK-V3SET
bridge USB interface description may miss). In that case, either the user switches to a more
recent version of the toolchain, or updates the ST-LINK driver from
www.st.com (see
Section 11.2 ).
11.2 Drivers and firmware upgrade
The STLINK-V3SET requires drivers to be installed on Windows and embeds a firmware
which needs to be updated from time to time in order to benefit from new functionality or
corrections. Refer to the
Overview of ST-LINK derivatives technical note (TN1235) for
details.
11.3 STLINK-V3SET frequency selection
The STLINK-V3SET can run internally at 3 different frequencies:
•
high-performance frequency
• standard frequency, compromising between performance and consumption
•
low-consumption frequency
By default, the STLINK-V3SET starts in high-performance frequency. It is the responsibility
of the toolchain provider to propose or not the frequency selection at the user's level.
11.4 Mass storage interface
The STLINK-V3SET implements a virtual mass storage interface allowing the programming
of an STM32 target flash memory with drag-and-drop action of a binary file from a file
explorer. This ability requires the STLINK-V3SET to identify the connected target before
Table 17. Toolchain versions supporting STLINK-V3SET
Toolchain Description
Minimum
Version
STM32CubeProgrammer ST Programming tool for ST microcontrollers 1.1.0
SW4STM32 Free IDE on Windows, Linux, and macOS 2.4.0
IAR EWARM Third-party debugger for STM32 8.20
Keil MDK-ARM Third-party debugger for STM32 5.26
STVP ST Programming tool for ST microcontrollers 3.4.1
STVD ST Debugging tool for STM8 4.3.12