Starting the Demo Application
UM0213 - User Manual
12/25
2.5.4
Front Panel Hotkeys
The “FRONT PANEL HOTKEYS” frame on the RC AND HOTKEYS CONFIG tab in
shows the settings used to configure the KS1/K2 key as a hot key (see
for more Front Panel key details).
Figure 9.
Front Panel Hot Key Configuration - as STANDBY
2.5.5 STANDBY
and
Wake-up Sequence
●
To put the VFD controller in STANDBY mode, choose the “READY LOW” option in the
“STANDBY CONTROL” frame on the WDT AND STANDBY tab.
●
When the VFD controller is in STANDBY mode, there are two ways to wake-up the
controller:
a)
pressing the remote control STANDBY key, and
b)
pressing the Front Panel Hotkey.
●
After the controller wakes up from STANDBY mode choose the “READY HIGH” option
in the “STANDBY CONTROL” frame on the WDT AND STANDBY tab within 10
seconds, otherwise, the controller will go into STANDBY mode again.
The decoded IR commands are passed on to the main processor through the serial
interface by sending 3 bytes of data. Labels in “READ RC DATA” frame on COMMAND tab
represents the 24 bits of these 3-byte data frames.
www.BDTIC.com/ST
