Figure 14.
Basic Mode functions
Step 2.
In the [
Button Control
] area, use the [
←
] and [
→
] arrow buttons to toggle through the preconfigured
demos available in the firmware.
You can use the [
Enable
] or [
Disable
] buttons to enable or disable the physical interface controls
available on the board.
Step 3.
In the [
Error Detection
] section, select an error checking frequency.
–
[
No Loop
]: error detection is performed once and the results are displayed
–
[
0.5 Sec Loop
]: error detection is performed every 0.5 s
–
[
1 Sec Loop
]: error detection is performed every 1 s
Figure 15.
Error Detection options
Step 4.
In the [
Brightness control for channel switching
] and [
Channel Switching
] sections, set individual
channels on and off, and control the brightness of the LEDs that are on with the slider.
The brightness is divided into 256 incremental levels.
UM2554
How to use the Basic Mode functions
UM2554
-
Rev 1
page 12/23
