ST ST7-EMU3 Series, User Manual, Page: 7 / 39

ST7-EMU3 series emulator Getting Started with ST7-EMU3
7/39
2.2 Quick set up for emulation configuration
1. Connect your PC to your ST Micro Connect box via parallel, USB or Ethernet port. For
more details refer to
Chapter 3: Connectivity on page 9 .
For Ethernet connections, you must assign your ST Micro Connect box an IP address.
For instructions refer to
Section 3.3: Ethernet connection on page 12 .
Caution: Before connecting your emulator and your application board, make sure that both your ST
Micro Connect box and the application board are powered OFF.
2. Fasten ferrite clips to the 80-wire flat cables connecting the ST Micro Connect box to
your EMU3 probe (see
Figure 4 ).
3. Connect your application board to the EMU3-probe. You can use the emulator without
connecting to your application board. For details about connecting to your application
board refer to your ST7xxxx-EMU3 Probe User Guide provided with your emulator.
Caution: Never have your application board powered on while the emulator is powered off—this can
cause serious damage to the emulator.
4. Connect the power supply to your ST Micro Connect box. For power supply
information, refer to
Section 4.3.3: Power supply on page 19 .
5. Power up your ST Micro Connect box.
6. Power up your application.
Caution: You must always power up your emulator and your application board before running your
application executable in STVD7. Doing otherwise will result in an erroneous emulation.
Figure 3. Connect your PC Figure 4. Fasten the ferrite clips
ST Micro Connect box
(back panel)
Parallel
Ethernet
USB
EMU3 probe
ST Micro Connect box