Emulation configuration
ST7-EMU3 series emulator
4.3.2
Probe connection cables
The ST Micro Connect box connects to your EMU3 probe via the two 80-wire flat cables
coming from the front panel. When you receive your emulator, the ST Micro Connect box
and the probe should already be connected (see
).
Figure 19.
Connecting the 80-pin cables to the EMU3 probe
To disconnect or reconnect the cables, do the following:
To disconnect the probe
1.
Power off your application board and the ST Micro Connect box.
2.
Unplug the long, 80-wire flat cable that is connected to port number 2 on top of the
probe. Grasp the sides of the plug, squeeze to release the two metal locks and pull
upwards, unplugging the cable from the port.
3.
Unplug the short, 80-wire flat cable that is connected to port number 1 in the same
manner.
To reconnect the probe
Plug the 80-wire flat cables back into their ports.
●
The short 80-wire flat cable (bottom) always plugs into port number 1.
●
The long 80-wire flat cable (top) always plugs into port number 2 (see
Upper cable (long)
Lower cable (short)
Micro Connect ports
EMU3 probe
ST Micro Connect box
1
2
&