Figure 14.
Connecting to the RF test points with the SMB adapter
it is listed what typical power levels can be expected while the ST25RU3993-EVAL board is
operating in its default configuration.
Table 19.
RF test points - default power levels
RF test
point
Description
Typical RF power level
RF-TP1
ST25RU3993 RF output signal (single-ended). Measure here to evaluate the power
and the spectral properties of the RF signal at the 0-dBm output. This RF signal is
the input for the external power amplifier.
-1.9 dBm
RF-TP2
External power amplifier RF output signal. Measure here to evaluate the power, Gain
and the spectral properties of the RF signal at the output of the external power
amplifier.
30.7 dBm
RF-TP3
Internal power amplifier RF output signal (single-ended). Measure here to evaluate
the power and the spectral properties of the RF signal at the output of the internal
power amplifier.
20.5 dBm
RF-TP4
RX signal. Measure here to evaluate the self-jammer signal or a RN16 tag response.
-14.5 dBm
-25 dBm (with Poynting
Patch-25 connected to
antenna port 1)
1. Internal power amplifier.
UM2353
Test points
UM2353
-
Rev 2
page 22/48
Summary of Contents for ST25RU3993-EVAL
