Figure 12.
Connection an ampere meter to the supply voltage test points
5.6.3
Digital test points
In addition to the four test points shown above a test point for each LED, connected to the STM32L476RG
controller is placed.
PLL OK:
Indicates that the PLL of ST25RU3993 is locked and the carrier frequency is stable.
OSC OK:
Low active. Indicates that the reference frequency for the PLL is stable.
No Tag Response:
Is pulled low if the sent reader command is not replied by a tag.
Tag CRC Error:
Is pulled low if a CRC error is detected within a tag response.
Tag found:
Is pulled low every time a tag has been inventoried.
EXT_PA:
Is pulled low if the reader is in its long range configuration.
INT_PA:
Is pulled low if the reader is in its short range configuration.
TUNING:
Is pulled low if the reader currently is re-tuning the carrier cancellation circuit.
Tuned:
Low active. Indicates that the self-jamming signal is sufficiently suppressed.
RF ON:
Low active. Indicates that the RF carrier is ON.
ANT1:
Low active. Indicates that antenna port 1 is active.
UM2353
Test points
UM2353
-
Rev 2
page 20/48
Summary of Contents for ST25RU3993-EVAL
