Usage:
1)
AT+S.STS<cr>
to get the full list of configuration variables
2)
AT+S.STS=<variable><cr>
to get the value of the specified variable
Parameters:
<variable>
Specifies the name of a variable. See
for a list of the available status variables
Result:
AT-S.Var:<var>=<value>
<var>
Specifies the status variable name
<value>
Specifies the status variable value
6.4
AT+S.PEERS
AT+S.PEERS displays the current values of the peer table. These values are useful to obtain additional
information about the module connected to the AP or about the client connected to the module when it is
configured in Mini AP mode.
Usage:
1)
AT+S.PEERS<cr>
returns the list of peers variable
2)
AT+S.PEERS=<peer_number><cr>
returns the list of peers variable for the peer_number peer
3)
AT+S.PEERS=<peer_number>,<peer_var><cr>
returns the specific value of a peer_variable
Parameters:
<peer_number>
identifier of the peer
<peer_var>
displays the current value of the specified peer variable. Refer
to
in the Appendix for a complete list
of the peer variables
Result:
AT-S.Var:<id>.<var>=<value>
<id>
Specifies the peer number
UM2114
AT+S.PEERS
UM2114
-
Rev 3
page 12/66
