UM1956 Rev 4
9/35
UM1956
Quick start
34
5 Quick
start
The STM32 Nucleo-32 board is a low-cost and easy-to-use development kit used to quickly
evaluate and start a development with an STM32 microcontroller in LQFP32 or UFQFPN32
package.
Before installing and using the product, accept the Evaluation Product License Agreement
that can be found at www.st.com/epla.
For more information on the STM32 Nucleo-32 board and to access the demonstration
software, visit the www.st.com/stm32nucleo webpage.
5.1 Getting
started
Follow the sequence below, to configure the STM32 Nucleo-32 board and launch the
demonstration software:
•
Check solder bridge position on the board, SB1 OFF, SB14 ON (internal regulator), JP1
ON (IDD) selected.
•
For a correct identification of all device interfaces from the host PC and before
connecting the board, install the Nucleo USB driver, available at the
www.st.com/stm32nucleo webpage.
•
To power the board connect the STM32 Nucleo-32 board to a PC through the USB
connector CN1 with a USB cable Type-A to Micro-B. The red LED LD2 (PWR) and LD1
(COM) light up and green LED LD3 blinks.
•
Remove the jumper placed between D2 (CN3 pin 5) and GND (CN3 pin 4).
•
Observe how the blinking frequency of the green LED LD3 changes, when the jumper
is in place or when it is removed.
•
The demonstration software and several software examples on how to use the STM32
Nucleo-32 board features, are available at the www.st.com/stm32nucleo webpage.
•
Develop an application using the available examples.
5.2 System
requirements
•
Windows
®
OS (7, 8 and 10), Linux
®
64-bit or macOS
®(a)
•
USB Type-A to Micro-B USB cable
a. macOS
®
is a trademark of Apple Inc. registered in the U.S. and other countries.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
