ST MB1361, User Manual, Page: 29 / 48

STM32 pin Signal name Pin name Pin Pin Pin name Signal name STM32 pin
USB_DP2 USB_DP2 D+ A6 B7 D- USB_DM2 USB_DM2
USB_DM2 USB_DM2 D- A7 B6 D+ USB_DP2 USB_DP2
- - SBU1 A8 B5 CC2 UCPD_CC2 PB15
-
VBUS_C/
5V_USB_C
VBUS A9 B4 VBUS
VBUS_C/
5V_USB_C
-
- - RX2- A10 B3 TX2- - -
- - RX2+ A11 B2 TX2+ - -
- GND GND A12 B1 GND GND -
6.14 Jumper configuration
The jumper default positions are explained in Table 4. Default jumper configuration , and shown in Figure 2 . The
Table 15 below explains the other jumper settings and configuration.
Table 15. Jumper configuration
Jumper / CN Definition Setting
(1)
Comment
CN4
T_SWCLK
T_SWDIO
ON [1-2] ON
[3-4]
ST-LINK/V2-1 enable for on-board MCU debugger
OFF
ST-LINK/V2-1 functions enabled for external CN5
connector
JP2 STLK_RST
ON [1-2] use to reset ST-LINK MCU
OFF Normal mode
JP3 T_NRST
ON ST-LINK able to reset target MCU
OFF
ST-LINK not able to reset target MCU configuration
to use when CN5 is used with external application
JP4 VDD_MCU voltage selection
ON [1-2] VDD_MCU voltage selection = 3V3
ON [2-3] VDD_MCU voltage selection = 1V8
OFF No VDD_MCU power supply (forbidden)
JP5 IDD measurement
ON [1-2] VDD =3V3
OFF
U6 LDO not used. External 3V3 source can be
connected on pin 2 (ULPBench probe as an
example)
JP6 5V Power selection
ON [1-2] 5V from ST-LINK
ON [3-4]
5V from ARDUINO
®
VIN 7 to 12 V
ON [5-6] 5V from 5V_EXT
ON [7-8]
5V from user USB_UCPD (USB Type-C
™
)
ON [9-10] 5V from USB_CHGR
OFF
No 5V Power source, configuration when external
3V3 is used
CN13 / CN14 GND NA GND probe
1. Default jumper state in bold.
UM2581
Jumper configuration
UM2581 - Rev 2
page 29/48