ST 32F072BDISCOVERY, User Manual, Page: 13 / 27

UM1690 Rev 3 13/27
UM1690 Hardware layout
26
5.1.2 Using ST-LINK/V2 to program/debug an external STM32 application
It is very easy to use the ST-LINK/V2 to program the STM32 on an external application.
Simply remove the 2 jumpers from CN5 as shown in
Figure 6 , and connect the application
to the CN4 debug connector according to Table 5 .
Note: SB10 must be OFF if CN4 pin 5 is used by the external application.
Figure 6. ST-LINK connections
Table 5. Debug connector CN4 (SWD)
Pin CN4 Designation
1 VDD_TARGET VDD from application
2 SWCLK SWD clock
3 GND Ground
4 SWDIO SWD data input/output
5 NRST Reset of the target MCU
6 SWO Reserved