ST 500 "Piranha" Operation Manual: Wired Receiver Channel
42
Controls:
Key
Action
navigation
ENTER
connecting/disconnecting the selected pin
F1
activating/deactivating the standard
8P8C
scheme
F2
activating/deactivating the standard
6P6C
scheme
F3
activating/deactivating the standard
6P4C
scheme
F4
activating/deactivating the standard
6P2C
scheme
ESC,
FUNC
exiting the mode (to the previous screen)
,
MODE
disabled
To finish the electronic switch setup and switch to "ELECTRONIC SWITCH CONTROL" mode,
press "FUNC" or "ESC".
If any pins have been disengaged in the setting-up stage, upon switching back to
"ELECTRONIC SWITCH CONTROL" mode, the table will look different.
Fig.38 shows the table, when the standard 6P6C connection scheme is used on the electronic
switch: pins #1 and #8 are off, and no paired combinations that include these wire connections
will be tested.
Fig.38
6.8. "PANORAMA" MODE (LOW CURRENT CIRCUIT TESTING)
To activate the "PANORAMA" mode, in "ELECTRONIC SWITCH CONTROL" mode select the pair
of wires to be monitored (
) and press "ENTER". Activity in the frequency band will be
displayed on the screen (fig.39).
