A. Loosely install the (2) mounting brackets onto the top of the
enclosure using (8) Phillips Screws and (8) washers. Brackets are
marked with a D (driver) or P (passenger) for correct orientation.
C. Place the WP3-PN3O4A onto the cage with the (2) J style brackets
resting on the front of the cage.
B. The enclosure brackets will utilize one safety net bolt on each side.
Remove both with a 10mm socket.
D. While holding the enclosure in position use the supplied 30mm hex
bolt (1) aluminum spacer and factory washer to secure the PN3O4
bracket to the safety net bracket. Do not tighten it all the way.
Repeat these steps on the opposing side.
E. Install both bottom J Brackets using (4) Phillips screws (8) Washers
and (4) lock nuts. Be sure rubber insterts are pre-installed.
WP3-PN3O4A
A
C
E
B
D
A. Cut the power/ground cable to length; be sure to leave
enough wire at the battery location to wire to the battery,
strip back approximately 4 inches of the black tubing to
expose the red/black wires inside.
Strip back 1/4”-1/2” of wire to make your connections.
B. Crimp the supplied
fuse holder onto the
end of the RED wire
and attach to the
battery “+” terminal.
C. Crimp the supplied
ring terminal to
the BLACK wire
and attach to the
battery “-” terminal.
WIRING INSTRUCTIONS
A
B
C
© 2018 SSV Works, Oxnard, CA 93030 WP3-PN3O4A Rev. B 2-21-18
F. After all the hardware has been loosely installed, make sure
the enclosure is seated properly then go back and tight on all
the mounting hardware.
Run all necessary cabling to the battery.